Notice: As of 4:26 p.m. EDT,
the GOES-16 ABI Imager (GOES-East) is offline due to a reported thermal anomaly.
No GOES-East images will be updated while the satellite is offline.
As soon as data flow is restored, we will begin processing images and update the site.
GOES-West continues to operate normally.
4 Jun 2024 - 23:46 EDT
5 Jun 2024 - 03:46 UTC
GOES-West Full Disk - Derived Motion Winds
2 hour loop - 12 images - 10 minute update
To enlarge, pause animation & click the image. Hover over popups to zoom. Use slider to navigate.
While GOES animation code will not run on older Internet Explorer browsers,
they work in the newest versions of Microsoft Edge. If you are using
Internet Explorer, please try a different browser: Chrome, Firefox, Safari, or
MS Edge are all supported.
Derived Motion Winds - Derived Motion Winds - 04 Jun 2024 - 1600 UTC
Derived Motion Winds - Derived Motion Winds - 04 Jun 2024 - 1700 UTC
Derived Motion Winds - Derived Motion Winds - 04 Jun 2024 - 1800 UTC
Derived Motion Winds - Derived Motion Winds - 04 Jun 2024 - 1900 UTC
Derived Motion Winds - Derived Motion Winds - 04 Jun 2024 - 2000 UTC
Derived Motion Winds - Derived Motion Winds - 04 Jun 2024 - 2100 UTC
Derived Motion Winds - Derived Motion Winds - 04 Jun 2024 - 2200 UTC
Derived Motion Winds - Derived Motion Winds - 04 Jun 2024 - 2300 UTC
Derived Motion Winds - Derived Motion Winds - 05 Jun 2024 - 0000 UTC
Derived Motion Winds - Derived Motion Winds - 05 Jun 2024 - 0100 UTC
Derived Motion Winds - Derived Motion Winds - 05 Jun 2024 - 0200 UTC
Derived Motion Winds - Derived Motion Winds - 05 Jun 2024 - 0300 UTC
Derived Motion Winds key:
Red barbs: High level winds: 100 - 400mb, altitude approximately 23,000 - 46,000 ft. (7-14 km)
Cyan barbs: Mid-level winds: 400 - 700mb, altitude: approximately 10,000 - 23,000 ft. (3 - 7 km)
Yellow barbs: Low-level winds: > 700mb, altitude: approximately < 10,000 ft. (< 3 km)
Derived Motion Wind Vectors (DMW) are produced using sequential ABI images and as such they can provide important information about winds at different levels during asynoptic times. Areas of wind shear or jet maxima can be identified. Wind Vectors are computed using both visible and infrared (including water vapor) imagery. DMWs are used to identify regions of strong winds or wind shear to confirm model forecasts and/or to anticipate the result of strong winds or shear.